Part Number and name: G1085 EZ rail (5’)
Used for/with: G778, sizes 24” -84”, G777 Small Log Mill.
Fits: Can be used with any horizontally-oriented mill. Larger crossbars available for logs of greater than four feet in diameter.
General description: Aircraft-grade aluminum rails provide a stable surface that attaches in seconds and is easily leveled left to right, front and back. Cross members are adjustable along whole length of the EZ rails. Requires G1090 connector kit if you plan to use with another EZ rail first cut system.
Use description: Hammer in dogs attached to cross members, set levels using a screwdriver or drill, then start milling
MADE IN THE USA
P65WARNING
Shipping weights and dimensions: 60”x4x3, 10lbs
Related products: G1080 (8’11” EZ rail extension – requires G1090 connector kit), 086F24 (24” crossbar), 1100F6 (Six-inch levelling screw)
M. Kitchen –
Easy to assemble and use. I find my results are much cleaner if the ez rail hangs over the starting end of the log enough to set my Alaskan Mill on before the chain makes contact with the log. This helps make sure the leading cut into the log is level and clean. So if you want to cut a full 5′ get a longer rail or buy 2 with the connector. When setting up be sure the depth of your Alaskan Mill is enough to clear the dogs you hammered in the top of the log for stability. Also make sure the level/stabilizing screws are below the top edge of the ez rails so your Mill doesn’t catch on them. All and all a great system that is lightweight and easy to use/store/transport.